Cautions On Installation; About The Remote Control Unit; Inserting The Batteries; Operating Range Of The Remote Control Unit - Denon DRA-37 - AM/FM Stereo Receiver Operating Instructions Manual

Getting Started
• Store the operating instructions in a safe place.
After reading the operating instructions, store them in a safe place
as they could come in handy in the future.
• Whenever the power operation button is in the STANDBY state,
the unit is still connected to AC line voltage.
Please be sure to turn off the power operation button or unplug
the cord when you leave home for, say, a vacation.
• Note that the illustrations in these instructions may differ from
the actual unit for explanation purposes.

Cautions on installation

Note:
For heat dispersal, do not install this unit in a confined space
such as a bookcase or similar enclosure.
Note

About the remote control unit

In addition to controlling the DRA-37, the attached remote control unit
(RC-1053) can also be used to control the following products:
q DENON component products
w Component products other than DENON:
• Set using the preset memory function (

Inserting the batteries

q Remove the remote control
unit's rear cover.
e Put the rear cover back on.
Notes on batteries:
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated nearby the unit.
(The attached batteries are only for verifying operation.)
• When inserting the batteries, be sure to do so in the proper
Wall
direction, following the "<" and ">" marks in the battery
compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries
in flames.
• Remove the batteries from the remote if it will not be in use for
long periods.
• If the battery fluid should leak, carefully wipe the fluid off the
inside of the battery compartment and insert new batteries.
• When replacing the batteries, have the new batteries ready and
insert them as quickly as possible.
ENGLISH

Operating range of the remote control unit

• Point the remote control unit at the remote sensor when operating
it.
• The remote control unit can be used from a distance of approximately
23 feet/7 meters, at a horizontal angle of up to 30° with respect to
the sensor.
page 17).
w Set two R6P/AA batteries in
the battery compartment in
the indicated direction.
NOTE:
• It may be difficult to operate the remote control unit if the remote
sensor is exposed to direct sunlight or strong artificial light.
2
Getting Started
30°
30°
Approx. 23 feet/7 m
ENGLISH