Fl Inverter Board - Toshiba Satellite A210 Series Maintenance Manual

4 Replacement Procedures

4.12 FL Inverter Board

Removing the FL Inverter Board
To remove the FL inverter board, first remove the battery pack, display assembly, and display
mask; then follow the steps below.
1. Remove the M2x3 black screw securing the FL inverter board to the LCD display
assembly.
NOTE: If a dual inverter board is installed, you must remove two additional M2.5x4
screws.
2. Disconnect the two connectors on either side of the board.
4-34
Figure 4-35 Removing the screw
Figure 4-36 Removing the connectors
Minnesota 10A/10AG Series Maintenance Manual