Installing A Drive Into The 3.5-Inch External Drive Bay - HP Pro 2000 - Microtower PC Maintenance And Service Manual

5. Remove the two retainer screws that secure the drive to the bay (1) then slide the drive forward
and out of the bay (2).
Figure 6-20

Installing a Drive into the 3.5-inch External Drive Bay

The 3.5-inch external drive bay on the front of the computer can be configured with a media card
reader.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then
remove the bezel blank.
5. If you are adding a drive to an empty drive bay for the first time, you must remove the knockout
plate from the bay. To do so, insert a flat screwdriver into the knockout plate slot and rotate the
screwdriver to break the knockout plate out of the chassis. Discard the knockout plate.
6. If the new drive has screws installed on the sides of the drive, remove them before inserting the
drive into the chassis.
Removing a 3.5-inch Device (Media Card Reader Shown)
(Access Panel on page
(Front Bezel on page
(Preparation for Disassembly on page
26).
27).
25).
Drives 45