3.
Position the cover over the chassis so that the front edge is approximately one inch away
from the front bezel.
4.
Lower the cover down over the chassis so that the rail guides engage the rails.
5.
Slide the cover forward. You might need to lift the front of the cover slightly to align it
properly.
6.
Insert the three thumbscrews into the holes in the cover and the chassis and tighten.
7.
Reconnect the external cables and cords to the computer. See "Installing external options"
on page 9.
Important
:
When the power cord is first plugged in, the computer might appear to power on for a
few seconds, then power off. This is a normal sequence to enable the computer to
self-initialize.
35