Regulatory And Safety Information; Energy Star Compliance - Compaq Presario S5000 - Desktop PC Support Manual

Regulatory and Safety Information

WARNING: The Compaq Presario is heavy; be
sure to use ergonomically correct lifting
procedures when moving the computer.
WARNING: Electrostatic discharge (ESD) can
damage disk drives, add-in cards, and other
components. If an ESD station is not available,
wear a wrist strap attached to a metal part of
the computer. Place cards on a conductive foam
pad or inside the conductive wrapper they came
in; do not place the cards on top of the wrapper.
WARNING: Do not operate the system with the
cover removed. Always replace the cover before
turning on the system.
WARNING: Please read the "Additional Safety
Information" located later in this document
before installing and connecting your system to
the electrical power system.
WARNING: Using the wrong type of memory
module could damage the system.
WARNING: Do not pull the memory module out
of the socket. Use the retaining clips to eject the
module.
WARNING: Do not overload the system by
installing add-in cards that draw excessive
current. The system is designed to provide
2 amps (average) of +5 V power for each
board/card in the computer. The total +5 V
current draw in a fully loaded system (one with
all add-in card slots filled) must not exceed the
total number of slots multiplied by 2 amps.
WARNING: Be careful of the sharp edges on the
expansion slot cover.
WARNING: There is danger of an explosion if the
battery is incorrectly replaced. Replace only with
the same, or equivalent, type of battery. Discard
used batteries according to the manufacturer's
instructions.

ENERGY STAR Compliance

Compaq Presario PCs and Monitors
marked with the ENERGY STAR
on the packaging box qualify with the
U.S. Environmental Protection Agency's
ENERGY STAR guidelines for energy efficiency.
Products with the ENERGY STAR label are designed to use
less energy, help you save money on utility bills, and help
protect the environment.
®
ENERGY STAR is a registered trademark owned by the
U.S. government.
Australia Telecom Statement
The computer must be connected to the
Telecommunication Network through a line cord that
meets the requirements of ACA Technical Standard TS008.
WARNING: Modems without integral RJ-11 that
are shipped with this computer must be installed
only in devices displaying the A-tick.
New Zealand Telecom Statement
The grant of a Telepermit for any item of terminal
equipment indicates only that Telecom has accepted that
the item complies with minimum conditions for connection
to its network. It indicates no endorsement of the product
by Telecom, nor does it provide any sort of warranty.
Above all, it provides no assurance that any item will work
correctly in all respects with another item of Telepermitted
equipment of a different make or model, nor does it imply
that any product is compatible with all of Telecom's
network services.
Some parameters required for compliance with Telecom's
Telepermit requirements are dependent on the equipment
(PC) associated with this modem. The associated
equipment shall be set to operate within the following
limits for compliance with Telecom's specification:
•
For automatically initiated calls to the same number:
•
There shall be no more than 10 call attempts to the
same number within any 30-minute period for a
single manual call initiation.
And
•
The equipment shall be on the hook for a period of
not less than 30 seconds between the end of one
attempt and the beginning of the next attempt.
®
logo
9