Channel Installation - Philips 32HFL4663D/F7 Quick Start Setup Manual

Channel installation

This section describes how to install the TV channels
automatically.
1
Connect the RF signal to the TV.
2
Plug the power cord into the power outlet.
3
Turn the TV on.
• Press . (POWER) at the front of the TV or use the
. (POWER) on the remote control.
4
Press RC5 SETUP to put the remote control into setup
mode, then press the HOME/MENU button to display
the setup menu. (Hereafter, HOME/MENU will be
simply referred to as MENU)
5
Select Consumer TV setup - Setup - Autoprogram;
then select Cable. (unless the installation is using only
Antenna signals - in which case you would select
Antenna)
Cable
7