11.
Remove the display bezel (3). Display bezels are available using the spare part numbers
447998-001 (for dual lamp display assemblies) and 447997-001 (for single lamp display
assemblies).
NOTE:
Display inverter on page 50
12.
If it is necessary to replace the display panel, remove the four Phillips PM2.5×8.0 screws (1) and
the two Phillips PM2.5×6.0 screws (2) that secure the display panel to the display enclosure.
13.
Remove the display panel (3). Display panels are available using the following spare part
numbers:
●
●
●
14.
If it is necessary to replace the display hinges, remove the two Phillips PM2.0×3.0 screws (1) that
secure each display hinge to the display panel.
15.
Remove the display hinges (2).
72
Chapter 4 Removal and replacement procedures
See
Camera module on page 48
447988-001 (17.0-inch, WXGA+, TFT, dual lamp, BrightView display assembly)
447987-001 (17.0-inch, SXGA+, TFT, single lamp, BrightView display assembly)
447986-001 (17.0-inch, WXGA+, TFT, single lamp, BrightView display assembly)
for camera module replacement instructions. See
for display inverter replacement instructions.