External Ports; System Management; Back-Up And Restore; Ip Addressing - HP BladeSystem bc2000 - Blade PC Installation Manual

External Ports

The HP PC Blade Switch includes eight external ports, four 10/100/1000T Mbps Ethernet "uplink" ports
with RJ-45 connectors, typically used to connect the switch to the network infrastructure, and four Small
Form-factor Pluggable (SFP) GBIC ports which can be used for Gigabit Fiber connectivity. These ports
are shared "combo" ports, whereas only one media type can be used at a time. Combo ports are single
ports with two physical connections, RJ-45 copper or SFP. If both devices are plugged in, the port that
takes priority can be defined through the switch CLI.
In addition, one external 10/100T Fast Ethernet port with an RJ-45 connector is provided for an optional
dedicated out-of-band management network or for local administration and diagnostic tasks without
unplugging one of the other dedicated uplinks. Although ideally suited for management, this port can
be used as an additional data uplink to the network.

System Management

Back-up and Restore

The PC Blade Switch supports trivial file transfer protocol (TFTP) allowing a copy of each switch
configuration file to be uploaded or downloaded. This provides a method to rapidly deploy multiple
switches with similar configurations and to provide backup and restore capabilities. Configuration
settings can be modified through the user interfaces or directly within the configuration file itself. The
configuration file may even be reset to the factory default settings at any time by first erasing the existing
startup-config, then rebooting the switch.
Users can perform firmware upgrades by using TFTP through any external Ethernet port after boot-up.
The switch simplifies firmware upgrades by retaining its configuration after an upgrade and by supporting
the HP Support Paq automated firmware process for Windows deployment stations.

IP Addressing

By default, the PC Blade Switch will automatically obtain an IP address from a Dynamic Host
Configuration Protocol (DHCP) or Bootstrap Protocol (BOOTP) server. Optionally, an administrator can
manually assign an IP address through the CLI or from the browser-based interface; however, they
would have to reconnect with the newly assigned IP address. For increased security, an administrator
can specify the IP-based management stations that are allowed to access the switch.

Web Browser-based Interface

Users can access the browser-based interface by using Internet Explorer or Netscape Navigator over
a TCP/IP network. The browser-based interface consists of three main sections:
●
The Active Virtual Graphic provides real time status of the switch panel and a means to quickly
view statistics of individual ports.
●
The Navigation Window contains particular items or features to select and configure.
4 Chapter 1 Introduction ENWW