Removing Trap Targets - HP BladeSystem bc2000 - Blade PC User Manual

The <IP address> must be in the form ###.###.###.###, where ### ranges from 0 to 255.
The Integrated Administrator only supports v1 traps and directs the traps to SNMP port 162 by default.
You can add a maximum of eight IP addresses to receive SNMP traps.

Removing Trap Targets

To remove a trap target list using the Web-based user interface:
1. Click the Enclosure tab.
2. Click SNMP Configuration in the left panel.
3. Type the list name in the appropriate field of the SNMP area.
4. Click Remove.
5. Click Apply.
To add or remove a trap target list using the CLI, type:
REMOVE SNMP TRAPRECEIVER <IP address>
The <IP address> must be in the form ###.###.###.###, where ### ranges from 0 to 255.
ENWW Configuring SNMP Support 87