Defining Rapid Spanning Tree - HP BladeSystem bc2000 - Blade PC User Manual

Configuring Spanning Tree

Defining Rapid Spanning Tree

While Classic STP prevents Layer 2 forwarding loops in a general network topology,
convergence can take between 30-60 seconds. This time may delay detecting possible loops and
propagating status topology changes. Rapid Spanning Tree Protocol (RSTP) detects and uses
network topologies that allow a faster STP convergence without creating forwarding loops. The
Global System LAG information displays the same field information as the ports, but represent
the LAG RSTP information.
To define RSTP on the device:
1. Click Layer 2 > Spanning Tree > Rapid STP. The Rapid STP page opens:
Rapid STP
✎
This image may not contain all possible fields for this page. The complete list is provided in the
following bullets.
The Rapid STP page contains the following fields:
■
Ports — Displays the Rapid STP information for ports.
■
LAGs — Displays the Rapid STP information for LAGs.
■
Interface — Displays the port or LAG on which Rapid STP is enabled.
■
Role — Displays the port role assigned by the STP algorithm to provide to STP paths. The
possible field values are:
❏
Root — Provides the lowest cost path to forward packets to the root switch.
❏
Designated — The port or LAG through which the designated switch is attached to the
LAN.
❏
Alternate — Provides an alternate path to the root switch from the root interface.
9-8 www.hp.com Embedded Web System User Guide