Switches And Jumpers - Asus P4BGL-VM User Manual

2.7

Switches and jumpers

The motherboard frequency is adjusted through the DIP switches. The
white block represents the switch position. The illustration below shows all
the switches in the ON position.
P4BGL-VM
P4BGL-VM DIP Switches
The J6 jumper must be set to pins 2-3 (jumper mode) if you wish to
use the DIP switches. Otherwise, setting the switches does not
produce any effect.
1. JumperFree™ mode (J6)
This jumper allows you to enable or disable the JumperFree™ mode.
The JumperFree mode allows you to change CPU settings through the
BIOS setup instead of using the DIP switches.
P4BGL-VM
P4BGL-VM JumperFree™ Mode Setting
For jumper mode, refer to the CPU frequency switch settings on the
next page.
2-16
®
®
SW1
1.Frequency Selection
2.Frequency Selection
3.Frequency Selection
4.Frequency Selection
5.Frequency Selection
J6
ON OFF
SW1
1 2
Jumper Free Jumper Mode
(Default)
Chapter 2: Hardware information
2 3