Table of Contents
Advertisement
4. USB device wake-up (3-pin USBPWR1, USBPWR2, USBPWR3)
Set these jumpers to +5V to wake up the computer from S1 sleep
mode (CPU stopped, DRAM refreshed, system running in low power
mode) using the connected USB devices. Set to +5VSB to wake up
from S3 sleep mode (no power to CPU, DRAM in slow refresh, power
supply in reduced power mode). All three jumpers are set to pins 1-2
(+5V) by default because not all computers have the appropriate power
supply to support this feature.
The USBPWR1 and the USBPWR2 jumpers are for the rear USB
ports. The USBPWR3 is for the internal USB header that you can
connect to the front USB ports..
1. This feature requires a power supply that can provide at least 1A
2. The total current consumed must NOT exceed the power supply
P4BGL-VM
P4BGL-VM USB Device Wake Up
2-18
on the +5VSB lead when these jumpers are set to +5VSB.
Otherwise, the system does not power up.
capability (+5VSB) whether under normal condition or in sleep
mode.
®
USBPWR2
USBPWR1
USBPWR3
1
2
2 3
+5V
+5VSB
(Default)
Chapter 2: Hardware information
Hide quick links:
Advertisement
Table of Contents
