Loading Paper; Connecting Cables - Kyocera FS-C8500DN Installation Manual

4

Loading Paper

1
Pull the paper cassette out toward you
until it stops.
5
Align the paper against the left side of
the paper cassette.
5

Connecting Cables

1
Turn the power switch off (O).
Refer to the Operation Guide to install the printer driver and to set network parameters.
© 2009 by KYOCERA MITA Corporation All rights reserved. 2-28, 1-Chome, Tamatsukuri, Chuo-ku, Osaka 540-8585, Japan
2
Adjust the paper length guide to the
length of the paper.
When loading A4/Letter or smaller paper
into paper cassette 1, raise the paper
length guide. For B4/Legal or larger
paper, lower the paper length guide.
Paper Length Guide
Important:
Ensure that the loaded paper
is not higher than the level indicator (see
illustration below).
Level Indicator
2
Connect the printer to the PC or your
network device. Use shielded interface
cables. These cables are sold
separately.
Network Interface
USB Interface
3
Grasp the paper width adjustment
knob and adjust the paper width guides
to the width of the paper.
Paper Width Adjustment Knob
6
Insert the appropriate paper size card
in the slot to indicate the size of the
paper.
3
Connect the power cord to the printer
and the other end into a power outlet.
4
Fan the paper, then tap it on a level
surface to avoid media jams or skewed
printing.
7
Gently push the paper cassette back
in.
4
Turn the power switch on (|).
Important: When the printer is first
switched on after installation, the printer
will begin cleaning the LSU; this will take
approximately 70 seconds.
Printed in China 302KA56030 First edition 2009.10