Lenovo ThinkServer RD330 Hardware Maintenance Manual page 149

8. Carefully lift up the backplane. When the hooks
holes in the backplane, slowly move the backplane a little bit outward. Then, completely remove the
backplane.
Figure 86. Removing the backplane
9. Touch the static-protective package that contains the new hot-swap hard disk drive backplane to any
unpainted surface on the outside of the server. Then, remove the new backplane from the package.
Note: Carefully handle the backplane by its edges.
1 on the chassis are aligned with the corresponding
.
Chapter 6 Installing, removing, or replacing hardware
135