Table of Contents
Advertisement
4059-XXX
User Error Message
36 Resolution Reduced
37 Insufficient Collation
Memory
38 Memory Full
39 Complex Page
51 Defective Flash
52 Flash Full
53 Unformatted Flash
54 Standard Serial Error
54 Serial Option X Error
Explanation
The resolution of the page has been reduced
from 600 dpi to 300 dpi in order to prevent a
Memory Full error. This message can only occur if
the Resolution Reduction setting is turned on.
Note: 1200 dpi pages are not resolution reduced.
If a 1200 dpi job runs out of memory, a Memory
Full error is displayed.
This message is displayed when the printer
memory used to store pages is too full to collate
the print job.
This message is displayed when the printer
memory used to store pages is full.
This message is displayed when the page is too
complex to print.
This message is displayed when the printer
detects a defective flash. This error may occur at
power on, or during flash format and write
operations. Press Go to clear the message. The
flash is marked as bad and normal operation
continues. Flash operations are not allowed until
the problem is resolved.
This message is displayed when there is not
enough free space in the flash memory to hold
the resources that have been requested to be
written to flash.
This message is displayed when the printer
detects an unformatted flash at power on. Press
Go to clear the message. The flash is marked as
bad and normal operation continues. Flash
operations are not allowed until the flash is
formatted.
This error is displayed when a serial error
(framing or parity) is detected on the standard
serial port. This usually indicates the serial port is
not set up correctly.
This error is displayed when a serial error
(framing or parity) is detected on the optional
serial port. This usually indicates the optional
serial port is not set up correctly.
Diagnostic Information
2-18
Advertisement
Table of Contents
