Table of Contents
Advertisement
6
6.
Place the canopy trim ring then the canopy over the adapter
as shown in Figure 15.
7.
Place the low profile washer (lip up) into the canopy as shown
in Figure 15 fitting the notch in the low profile washer over the
adapter set screw and hook.
Tab Hole
Figure 15 - Assembling canopy for low profile mounting
8.
Rotate the canopy until the arrow on the low profile washer
aligns with the tab hole on the canopy as shown in Figure 15.
9.
Align the holes in the low profile washer with the holes in the
adapter and assemble securely with the three #8-32 x 3/4"
screws.
hanging the fan
1.
Raise the fan and place the hook through the loop on the ceil-
ing plate as shown in Figure 16. Use the note and arrow en-
graved in the ceiling plate to assist in determining the direc-
tion to assemble.
WARNING: Fan may fall if not assembled as directed in
these installation instructions.
Hook
Figure 16 - Hanging the fan
wiring the fan
1.
Disconnect the power by turning off the circuit breakers to
the outlet box and associated wall switch location.
2.
Connect the wires as shown in Figure 17. To connect the wires,
twist the bare metal leads together. Place a wire nut over the
intertwined length of wire and twist clockwise until tight as.
CAUTION: Be sure no bare wire or wire strands are vis-
ible after making connections.
All wiring must be in accordance with national and local
electrical codes and ANSI/NFPA 70. If you are unfamiliar
with wiring, you should use a qualified electrician.
41857-01 02/22/2005
Low Profile Washer
Canopy
Canopy Trim Ring
Arrow on the
Low Profile
Washer
Loop
Power
Black
Wires
in
White
Ceiling
Bare or Green
2 x 4 Brace
Approved
Connectors
Green Ground Wire from
Hanger Pipe (not present
with flush mounting
option)
Figure 17 - Wiring the fan
installing the canopy
1.
Rotate the fan 180º clockwise from the initial position when
hanging the fan. The arrows on the hanger ball and on the
ceiling plate should be pointing in the same direction and
should be pointing towards the tab hole on the canopy. Refer
to Figure 18.
Figure 18 - Rotating the fan
For Flush Mounting: The arrows on the low profile washer and
on the ceiling plate should be pointing in the same direction
and should be pointing towards the tab hole on the canopy.
2.
Hook the tab hole over the tab on the ceiling plate as shown in
Figure 19.
3.
Raise the canopy, be sure the holes in the canopy and the ceil-
ing plate are aligned, and loosely assemble the canopy screws
one at a time. When all three screws are assembled, securely
tighten all three canopy screws. Refer to Figure 19.
Outlet Box
Ceiling Plate
© 2005 Hunter Fan Company
Advertisement
Table of Contents
