Power Cord; Power Switch - Bissell Trilogy® Vacuum User Manual

A
ssembly
attach carpet spot & stain remover pet holster
1. Locate the bag that contains carpet spot &
stain remover holster and can.
2. Attach holster to left side of vacuum (when
viewing from front) by lining up the two tabs
on the back side of the holster with the two
openings on the vacuum. Push holster down
to lock into place.
3. Place provided can of carpet spot & stain
remover*into holster. Follow instructions on
page 8 for carpet spot & stain remover.*
O
perations

power cord

To store power cord, wrap cord around upper
cord wrap and lower extension wand support.
Use clip on the end of the plug to attach plug
to the cord.
To release power cord, rotate the upper cord
wrap down and gently pull off cord.

power switch

The power button is located just below the
handle on the right side of the vacuum when
viewing from the front. "ON" (I) "OFF" (O).
note: Rotating brush will not turn
on unless the unit is in reclined
position and brush switch is on.
brush on/off switch
Brush ON/OFF is located just below the handle
on the right side of the vacuum when viewing
from the front. Push the rocker switch ON- (I) to
turn brush on for most carpeted surfaces, when
"ON" the brush will start rotating when unit is in
reclined position. Push rocker switch OFF – (O)
to turn brush off for bare floor cleaning or other
delicate surfaces.
* Carpet spot & stain remover varies by model.
Refer to page 4.
6
w w w . b i s s e l l . c o m
Power Cord
Wrap
Power
Switch
attention:
Some frieze carpets have long delicate
fibers or threads that may be damaged
by the rotating brush during vacuuming.
It is recommended the rotating brush
be turned OFF when cleaning this type
of carpet.
Brush
ON/Off
Switch
8 0 0 . 2 3 7 . 7 6 9 1