Epson WorkForce AL-MX200DNF User Manual page 280

IPv4 Get IP Address
IP Address
Subnet Mask
Gateway Address
*
Factory default menu setting
Note:
To configure the IPv6 settings, use EpsonNet Config.
Protocol
Purpose:
To enable or disable each protocol. To make any changes effective, turn off the printer and then turn it
back on.
Values:
LPD
Port 9100
*2
WSD
SNMP
StatusMessenger
*
DHCP/AutoIP
BOOTP
RARP
DHCP
Panel
Disable Disables the Line Printer Daemon (LPD) port.
*1
Enables the LPD port.
Enable
Disable Disables the Port 9100 port.
*1
Enables the Port 9100 port.
Enable
Disable Disables the Web Services on Devices port.
*1
Enables the Web Services on Devices port.
Enable
Disable Disables the Simple Network Management Protocol (SNMP) UDP port.
*1
Enables the SNMP UDP port.
Enable
Disable Disables the StatusMessenger feature.
*1
Enables the StatusMessenger feature.
Enable
AL-MX200 Series
Automatically sets the IP address.
Uses BOOTP to set the IP address.
Uses RARP to set the IP address.
Uses DHCP to set the IP address.
Enter the IP address on the operator panel.
Enter the IP address allocated to the printer.
Enter the subnet mask.
Enter the gateway address.
Using the Operator Panel Menus and Keypad
User's Guide
280