Programming The Remote Control To Control Your Other Devices - Toshiba 46RV525RZ Owner's Manual

SLOWREW*
SLOWFWD*
Angle*
Sub title*
Audio*
Eject*
DVDAngle
DVD Sub title
DVDAudio
DVD Eject
• In addition to POWER, confirm that all necessary
keys on the TV remote control operate your device.
If some keys are not operational, repeat the device
code setup using another code (if other codes
are listed for your device). If, after trying all listed
codes, the necessary keys do not operate your
device, use the device's original remote control.
• Every time you change the batteries, you will need
to reprogram the remote control.
Some newer VCRs respond to either of two codes.
These VCRs have
a
switch labeled "VCR1NCR2."
If your VCR has this kind of switch and does not
respond to the codes for your VCR brand, set the
switch to the other position ("VCR 1" or "VCR2")
and reprogram the remote control.
Note:
I
I •
Your Toshiba TV remote control is preprogrammed
to operate most Toshiba devices. To program your
TV remote control to operate a oon-Toshiba device
(or a Toshiba device that it is not preprogrammed to
operate), follow the steps below. For details on using
the remote control to operate the device, see page 22.
1 In the remote control code table
(IrE
page 25), find the
code for your device.
If
more than one code is listed,
try each one separately until you find one that works.
2 Set the MODE SELECT switch to the type of device you are
programming the remote control to operate - CABLE/
SAT (for a cable converter box or satellite receiver), AUX
I (for ~ VCR or TVNCR combo), or AUX 2 (for a DVD
player or HTIB [home theater in a box]).
3 While holding down
RE3LL,
press the Channel Number
buttons to enter the 3-digit code for your device.
4 To test the code, turn on the device, point the remote
control at it, and press
P~ER.
See notes below.
• If the correct code was entered, the device will
turn off.
• If the device does not respond, repeat steps 1-4
using another code.
• If the device does not respond to another code,
you will need to use the remote control that came
with the device.
5 Remember to set the MODE SELECT switch back to
"TV" to control the TV.
6 For future reference, write down the code(s) you used:
..
··~~i-·--_
Programming the remote control
to control your other devices
I
24