Programming The Remote Control To Control Your Other Devices - Toshiba 40XV648U Owner's Manual

Programming the remote control
to control your other devices
Your Toshiba TV remote control is preprogrammed to
operate most Toshiba devices. To program your TV
remote control to operate a non-Toshiba device (or a
Toshiba device that it is not preprogrammed to
operate), follow the steps below. For details on using
the remote control to operate the device, see page 21.
1
In the remote control code table (- pages 24–25),
find the code for your device. If more than one code
is listed, try each one separately until you find one
that works.
2
Set the MODE SELECT switch to the type of device
you are programming the remote control to operate
— CABLE/SAT (for a cable converter box or
satellite receiver), AUX1 (for a VCR or TV/VCR
combo), or AUX2 (for a DVD player or HTIB [home
theater in a box]).
3
While holding down E, press the Channel
Number buttons to enter the 3-digit code for your
device.
4
To test the code, turn on the device, point the
remote control at it, and press p. See notes below.
• If the correct code was entered, the device will turn
off.
• If the device does not respond, repeat steps 1–4
using another code.
• If the device does not respond to another code, you
will need to use the remote control that came with
the device.
5
Remember to set the MODE SELECT switch back to
"TV" to control the TV.
6
For future reference, write down the code(s) you
used:
DEVICE CODE
Note:
• In addition to POWER, confirm that all necessary keys
on the TV remote control operate your device. If some
keys are not operational, repeat the device code setup
using another code (if other codes are listed for your
device). If, after trying all listed codes, the necessary
keys do not operate your device, use the device's
original remote control.
• Every time you change the batteries, you will need to
reprogram the remote control.
XV648U_06C03.pdf 5
Chapter 3: Using the remote control
DEVICE CODE
• Some newer VCRs respond to either of two codes.
These VCRs have a switch labeled "VCR1/VCR2." If
your VCR has this kind of switch and does not respond
to the codes for your VCR brand, set the switch to the
other position ("VCR1" or "VCR2") and reprogram the
remote control.
23
2009/07/10 11:00:10