Programming Channels Into The Tv's Channel Memory; Programming Channels Automatically; Manually Adding And Deleting Channels In The Channel Memory - Toshiba 46RV525RZ Owner's Manual

Programming channels into the
TV's channel memory
4
(A new set of
Installation
menu icons will
appear, as shown below.) Open the
Terrestrial
menu, highlight
Channel Program
to bring up
the
Start
and press
@
again to begin channel
programm ing.
~
ICHI
When you press ICHI or
~
on the remote control
or TV control panel, your TV will stop only on the
channels you programmed into the TV's channel
memory.
Follow the steps below to program channels into the
TV's channel memory.
Programming channels automatically
Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
Sleep Timer
PC Settings
Logo LED
Off
Terrestrial
BHml!lD!!IUU III
tIl
Note:
• You must configure the ANT/CABLE input
source before programming channels
(VIi
page 29)
• The automatic channel programming process
will erases channels that were previously
programmed into the TV's memory
• To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
• Programming channels when the ANT/
CABLE input is configured for Cable will take
substantially longer than when the antenna
input is configured for Antenna. This is
normal; however. once channel programming
is finished, you should not have to repeat
the programming process again unless
your Cable TV service lineup changes
significantly
To program channels automatically:
1
Configure the antenna input source, if you have
not already done so
(1G'f
page 29).
2
MENU
Press 0 and open the
Setup
menu.
3
Highlight
Installation
and press
@.
I
30
The TV will automatically cycle through all the
antenna channels, and store all active channels
in the channel memory. While the TV is cycling
through the channels, the message "Scanning
channels, please wait" appears (as shown
above).
5
.
EXIT
To cancel channel programmJng, press 0 on
the remote control (or highlight
Cancel
in the on-
screen display and press
8).
When channel programming is finished, press
(£I
ICHI .
I
or
~
to view the programmed channe s.
Manually adding and deleting
channels in the channel memory
After automatically programming channels into the
channel memory, you can manually add or delete
individual channels.
To add or delete channels in the channel
memory:
1
From the
Setup
menu, highlight
Installation
and
press
@.
A new set of
Installation
menu icons
will appear.
(continued)