Advertisement
ASSEMBLY : YV-2700/2700G/1600A/520
For YV-1600A/520
Loosen the center rod fixing bolts to
extend the center rod, and insert the
center rod into the fitting of the rod
connector. Align the groove in the
center rod with the tip of the fixing
bolt, and then securely tighten the
fixing bolt.
10
Stand up the vibes, and attach the resonators. (Refer to YV-3910/3710/3700 assembly
v
step
on page 12.)
11
Mount the driver and the controller, and connect them using the supplied 8P DIN cable.
(Refer to YV-3910/3710/3700 assembly steps
12
Attach the round belt (fan belt)*.
Slip the round belt (fan belt) over the fan side pulley first, and then pull it over the flange of
the driver pulley.
*
Note For Service Personnel
If the belt cannot be mounted because the distance between the pulleys is too wide,
or the belt slips due to a too narrow pulley distance, loosen the two driver positioning
screws (see illustration below) to adjust the pulley distance (belt tension). Tighten the
screws securely after adjustment.
Fan Side
Pulley
24
Groove
n
Round Belt
(Fan Belt)
Round Belt
(Fan Belt)
* In case the belt is misplaced or worn, the following spare part may be ordered:
Model
YV-2700/2700G
YV-1600A/520
Rod Connector
,
through
on pages 14 and 15.)
Driver Side
Pulley
Part No.
Part Name
W5 128041
Fan Belt
W5 128070
Fan Belt
Tighten
Center Rod
Pedal Rod
Driver Positioning
Screws
Specification
3ØL275
3ØL236
Advertisement
