Yamaha Arius YDP-V240 Owner's Manual page 116

Keyboard Stand Assembly
5
Mount A.
5-1
Place your hands at least 15 cm from either
end of A when positioning it.
A
E
At least 15 cm
6
Secure A.
6-1
Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
6-2
Secure A by tightening the short screws (6 x
16mm) from the front.
6-1
Projection of A
6-2
116
Owner's Manual
D
A
A
7
Connect the pedal cord and the power
cord.
7-1
Insert the pedal cord plug to the pedal connec-
tor from the rear.
7-2 Attach the cord holders to B, then clip the cord
into the holders.
7-3
Use a vinyl tie to bundle the pedal cord.
7-4
For models that feature a voltage selector: Set
the voltage selector to an appropriate voltage.
Voltage Selector
Before connecting the AC power cord, check the
setting of the voltage selector which is provided in
some areas. To set the selector for 110V, 127V,
220V or 240V main voltages, use a "minus" screw-
driver to rotate the selector dial so that the correct
voltage for your region appears next to the pointer
on the panel. The voltage selector is set at 240V
when the unit is initially shipped. After the proper
voltage has been selected, connect the AC power
cord to the AC INLET and an AC wall outlet. A
plug adaptor may be also provided in some areas to
match the pin configuration of the AC wall outlets
in your area.
WARNING
• An improper voltage setting can cause serious damage to
this instrument or result in improper operation.
7-5 Insert the AC power cord plug into the AC
INLET.
7-3
7-5 7-4
7-1
7-2