Yamaha disklavier DKC-850 Operation Manual page 22

Important
Be sure to backup the data on your control unit to the floppy disk before connecting.
1
Turn on your piano, and reset settings on your control unit
to its factory default.
For details on setting, refer to your piano's owner's manual.
2
Turn off your piano, and disconnect the power cable from
the AC wall outlet.
3
Connect the MIDI IN terminal of your control unit to the
MIDI OUT terminal of the rear panel of the Disklavier
control unit with the supplied MIDI cable.
4
Connect the MIDI OUT terminal of your control unit to the
MIDI IN terminal of the rear panel of the Disklavier control
unit with the supplied MIDI cable.
5
Connect monitor speakers to the OUTPUT jack on the rear
panel of the Disklavier control unit.
6
Connect the supplied AC adaptor to the DC-IN 12V
connector on the rear panel of the Disklavier control unit.
7
Connect the supplied power cable to the AC adaptor.
8
Connect the power cable extended from your piano and
the AC adaptor to the AC wall outlet.
9
Place the remote control sensor shielding sticker over the
remote control sensor of the control unit of your piano.
The remote control supplied with the Disklavier control unit will also
operate the control unit of your piano. In order to prevent this, be
sure to place the remote control sensor shielding sticker.
10
Turn on your piano, and make the MIDI data transmission/
reception settings on the control unit of your piano.
Make the settings as follows. For details on setting, refer to your
piano's owner's manual.
Settings
MIDI IN CH HP
MIDI IN DELAY IN (500ms)
MIDI OUT KBD OUT
OUT CH HP
The connection completed.
Turn on the Disklavier control unit, and set the piano type.
Getting Started
Note:
The location of the MIDI IN/MIDI
OUT terminals varies depending on
the piano model.
Note:
Be sure to connect your control unit
and the Disklavier control unit with
two MIDI cables for input and
output.

See Chapter 2 "Getting Started –
Connecting Monitor Speakers" on
page 12.
Note:
For the location of the remote
control sensor, refer to your piano's
owner's manual.
Note:
If you connect your control unit,
which is replaceable with the
Disklavier control unit, with the
MIDI cables, set the HOST
SELECT switch on your control unit
to the "MIDI" position.

See Chapter 2 "Getting Started –
Setting the Type of Your Piano" on
page 15.
Chapter
2
11