Configuring Vt6410 Ide Controller Mode And Boot Sequence In Bios Setup - Gigabyte GA-8I915G Duo Manual

(2) Configuring VT6410 IDE controller mode and boot sequence in BIOS Setup

You have to make sure whether the VT6410 IDE controller are configured correctly in system BIOS
Setup and set BIOS boot sequence for the IDE RAID hard drive(s).
Step 1:
Turn on your computer and press the Del key to enter BIOS Setup during POST (Power-On Self Test).
To enable the VT6410 IDE controller, please select Onboard H/W RAID under the Integrated
Peripherals menu and then press ENTER. Make sure the Onboard H/W RAID item is set to
Enabled (Enabled by default) (Figure 1). If you set this option to Disabled, the VT6410 IDE controller
will be disabled and will not support any devices.
On-Chip Primary PCI IDE
SATA RAID/AHCI Mode
x On-Chip SATA Mode
x PATA IDE Set to
SATA Port 0/2 Set to
SATA Port 1/3 Set to
USB Controller
USB 2.0 Controller
USB Keyboard Support
USB Mouse Support
Azalia Codec
Onboard H/W RAID
Onboard H/W 1394
Onboard H/W LAN1
Onboard H/W LAN2
Onboard LAN1 Boot ROM
Onboard LAN2 Boot ROM
Onboard Serial Port 1
Onboard IrDA Port
: Move Enter: Select
F5: Previous Values
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Enabled]
[RAID]
Auto
Ch.1 Master/Slave
Ch.2 Master/Slave
Ch.3 Master/Slave
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Auto]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[3F8/IRQ4]
[2F8/IRQ]
F10: Save
Figure 1
- 3 - VIA VT6410 IDE RAID Drives Configuration
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults