Advertisement
(2) Configuring SATA controller mode and boot sequence in BIOS Setup
You have to make sure whether the SATA controller is configured correctly in system BIOS Setup and
set BIOS boot sequence for the SATA hard drive(s).
Step 1:
Turn on your computer and press Del to enter BIOS Setup during POST (Power-On Self Test). In the
BIOS Setup menu, go to the Integrated Peripherals menu and assure that the OnChip SATA is
enabled. If you want to create RAID, set OnChip SATA Mode to RAID (RAID by default). Set OnChip
SATA Mode to IDE if you do not want to create RAID.
OnChip Audio
OnChip SATA
OnChip SATA Mode
On-Chip Primary IDE
On-Chip Secondary IDE
IDE DMA transfer access
Onboard H/W LAN
USB 1.1 Controller
USB Keyboard Support
USB Mouse Support
USB 2.0 Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
x UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
Game Port Address
Midi Port Address
higf: Move
Enter: Select
F5: Previous Values
The BIOS Setup menus described in this section may not show the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Integrated Peripherals
[Enabled]
[Enabled]
[RAID]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
Half
[378/IRQ7]
[PRINTER]
[201]
[Disabled]
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Figure 1
F10: Save
ESC: Exit
F7: Optimized Defaults
- 3 -
SATA Hard Drive Configurations (ULi M1689)
Item Help
Menu Level}
F1: General Help
Advertisement
