Table of Contents
Advertisement
GigaRAID (IT8212) ATA RAID Controller USER'S MANUAL
Windows 2000
Install the driver during Windows 2000 installation
1.
Start Windows 2000 installation.
!
Boot from floppy with Windows installation diskette.
Boot from floppy with un-installable diskette.
Boot from CD-ROM with Windows installation CD.
2.
When the message "Press F6 if you need to install third party SCSI or
RAID driver" appears on the bottom of the screen, please press the <F6> key.
3.
The installation will continue. When a message appears to ask you to
designate the device you want to install, press the <S> key.
4.
Follow the instruction of the installation program to insert the GigaRAID
(IT8212) ATA RAID Controller Driver diskette into the floppy disk drive then
press the <Enter> key to continue.
5.
Select GigaRAID (IT8212) ATA RAID Controller (Windows 2000/XP) from the
device list shown on the window then press the <Enter> key to continue.
6.
The devices that are going to be installed will be listed on the next window.
GigaRAID (IT8212) ATA RAID Controller (Windows 2000/XP) should be
contained on
the list. If you need to install any other devices, please designate them now.
After designating all the devices, please proceed to the next step.
7.
Press the <Enter> key to continue the installation of Windows 2000.
Warning: Because of the different selections of the
following installation methods, the time when step2 starts
will be different.
45
Advertisement
Table of Contents
