Setting The Video System; Setting The Video Setup; Checking The Input Signal - Sharp PG-LW3000 Operation Manual

Signal Adjustment ("SIG-ADJ" Menu)
(Continued)

5 Setting the Video System

The video input system mode is factory preset
to "Auto"; however, a clear picture from the
connected audio-visual equipment may not be
received, depending on the Video signal
difference.
In that case, switch the Video signal.
Selectable items
Auto
PAL
SECAM
*NTSC4.43
NTSC3.58
PAL­M
PAL­N
PAL­60
* When reproducing NTSC signals in PAL
video equipment.
Note
• The Video signal can only be set in VIDEO
mode.
• When "Video System" is set to "Auto", you
may not receive a clear picture due to signal
differences. Should this occur, switch to the
video system of the source signal.
46
Menu operation n Page

6 Setting the Video Setup

Selectable
items
0 IRE Sets the black level to 0 IRE.
7.5 IRE Sets the black level to 7.5 IRE.
Note
• This function is available for the following
signals.
With COMPUTER/COMPONENT input:
­ 480I
With VIDEO input:
­ NTSC3.58

7 Checking the Input Signal

This function allows you to check the current
input signal information.
40
Description