7 • Completing Your Installation With a Bowl Light Fixture
Your Hunter fan comes with an integrated light fixture assembly .
WARNING: Use only the light fixture supplied with this fan model .
7-1 . To attach the upper switch housing, partially install two housing
assembly screws into the switch housing mounting plate .
7-2 . Feed the upper plug connector through the center opening of the
housing .
7-3 . Align the keyhole slots in the housing with the housing assembly
screws .
7-4 . Turn the housing counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole slots .
Install the remaining screw into the housing . Tighten all three
screws firmly .
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate . Failure to properly
attach and tighten all three assembly screws could result in the
switch housing and light fixture falling .
12
42823-01 • 04/13/10 • Hunter Fan Company
Steps 7-1 – 7-3
Housing
Upper
Assembly
Switch
Screw
Housing