Ant+ Sensors; Viewing Your Ride; Deleting History - Garmin Edge 510 Quick Start Manual

When the device memory is full, a message appears. The
device does not automatically delete or overwrite your history.
Upload your history to Garmin Connect periodically to keep
track of all your ride data.

Viewing Your Ride

1
From the home screen, select
2
Select Last Ride or All Rides.
3
Select an option.

Deleting History

1
From the home screen, select
2 Select an option:
• Select All Rides to delete all saved activities from the
history.
• Select Old Rides to delete activities recorded more than
one month ago.
• Select All Totals to reset all distance and time totals.
NOTE: This does not delete any saved activities.
• Select All Courses to delete all courses you have saved
or transferred to the device.
• Select All Workouts to delete all workouts you have
saved or transferred to the device.
• Select All Personal Records to delete all personal
records saved to the device.
NOTE: This does not delete any saved activities.
3
Select .

ANT+ Sensors

Your device can be used with wireless ANT+ sensors. For more
information about compatibility and purchasing optional
sensors, go to http://buy.garmin.com.
Putting On the Heart Rate Monitor
NOTE: If you do not have a heart rate monitor, you can skip this
task.
You should wear the heart rate monitor directly on your skin,
just below your breastplate. It should be snug enough to stay in
place during your activity.
1 Snap the heart rate monitor module
2 Wet both electrodes
strong connection between your chest and the transmitter.
3
If the heart rate monitor has a contact patch
contact patch.
4
Wrap the strap around your chest, and connect the strap
hook to the loop.
The Garmin logo should be right-side up.
5
Bring the device within range (3 m) of the heart rate monitor.
After you put on the heart rate monitor, it is on standby and
ready to send data.
TIP: If the heart rate data is erratic or does not appear, you may
have to tighten the strap on your chest or warm up for 5–10
minutes.
> Rides.
> Delete.
onto the strap.
on the back of the strap to create a
, wet the
Installing the GSC 10
NOTE: If you do not have a GSC 10, you can skip this task.
Both magnets must be aligned with their respective indication
lines for the Edge to receive data.
1
Place the GSC 10 on the rear chain stay (on the side
opposite the drive train).
2
If necessary, place the flat rubber pad
shaped rubber pad between the GSC 10 and the chain stay
for stability.
3
Loosely attach the GSC 10 using two cable ties
4
Attach the pedal magnet
adhesive mount and a cable tie
The pedal magnet must be within 5 mm of the GSC 10. The
indication line on the pedal magnet must line up with the
indication line on the GSC 10.
5 Unscrew the spoke magnet
6
Place the spoke in the groove of the plastic piece, and
tighten it slightly.
The spoke magnet can face away from the GSC 10 if there is
not enough room between the sensor arm and the spoke.
The spoke magnet must line up with the indication line
the sensor arm.
7
Loosen the screw on the sensor arm.
8
Move the sensor arm to within 5 mm of the spoke magnet.
You can also tilt the GSC 10 closer to either magnet to
improve alignment.
9
Select Reset on the GSC 10.
or the triangle-
.
to the crank arm using the
.
from the plastic piece.
on
5