Table of Contents
Advertisement
NOTE: If you hold the Power key for less than 5 seconds,
the device enters sleep mode
2
Select Off.
Resetting the Device
You can reset your device if it stops functioning.
Hold the Power key for 10 seconds.
About Sleep Mode
Use sleep mode to conserve battery power when your device is
not in use. Sleep mode uses very little power, and a battery
charge lasts for weeks when your device is in sleep mode.
Entering Sleep Mode
Press the Power key.
Exiting Sleep Mode
While the device is in sleep mode, press the Power key.
Adjusting the Screen Brightness
1
Select Settings > Display > Brightness.
2
Use the slider bar to adjust the brightness.
Adjusting the Volume
1
Select Volume.
2
Select an option:
• Use the slider bar to adjust the volume.
• Select
to mute the device.
• Select
> Audio Mixer and use the slider bars to adjust
the volume for navigation prompts, phone, and media.
About Automatic Volume
On devices with hands-free calling, automatic volume allows the
device to adjust the volume level based on the background
noise in the vehicle
(page
9).
Automatic volume control lowers the volume of the device when
background noise is low and raises the volume level when
background noise increases.
Enabling Automatic Volume
Your device can increase or decrease the volume automatically
based on the level of background noise.
Select Volume >
> Automatic Volume.
Status Bar Icons
The status bar is located at the top of the main menu. The
status bar icons display information about features on the
device. You can select some icons to change settings or view
additional information.
2
(page
2).
GPS signal status.
Bluetooth ® technology status (appears when Bluetooth is
enabled).
Transportation mode indicator.
Current time.
Battery status.
Acquiring GPS Signals
To navigate with your device, you must acquire satellites.
the status bar indicates the satellite signal strength (see
page
2). Acquiring satellites can take several minutes.
1
Turn on the device.
2
If necessary, go outdoors to an open area, away from tall
buildings and trees.
3
If necessary, hold
to view detailed information about the
satellite signals.
Viewing GPS Signal Status
Hold
for three seconds.
Transportation Modes
Truck mode
RV mode
Automobile mode
Routing and navigation are calculated differently based on your
transportation mode.
Choosing a Transportation Mode
Select
.
Battery Information
After the device is connected to power, it begins to charge.
in the status bar indicates the status of the internal battery.
To increase the accuracy of the battery gauge, you should fully
discharge the battery and then fully charge it. Do not unplug the
device until it is fully charged.
Setting the Time
NOTE: You can select Automatic to automatically set the time
each time the device is powered on.
1
Select
.
2
Scroll the numbers to set the time.
Using a Backup Camera
Keep your eyes and mind on driving while using the backup
camera. Using a backup camera is an enhancement for safety
practices. The backup camera is not a replacement for driver
attentiveness and good judgment.
If a composite video backup camera has been installed in your
vehicle, you can view the output of the camera on your device.
1
If necessary, connect the camera to the video-in jack
the mount.
WARNING
Getting Started
in
on
Hide quick links:
Advertisement
Table of Contents
