Maintenance; Filter Bag - Hoover UH30600 Owner's Manual

Familiarize yourself with these home maintenance tasks as proper use and care of your vacuum will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.
A Thermal Protector has been designed into your cleaner to protect it from overheating. When the
thermal protector activates the cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Replace Filter Bag.
3. Inspect and remove blockage along the dirt path. This blockage may occur at the: nozzle inlet,
hose connector, hose, bag opening inlet, secondary filter and final filter.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate
and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner
needs servicing.

FILTER BAG:

When to Replace
Check filter bag from time to time. It is recommended
that you change the filter bag when dirt reaches the
dotted line. If more dirt than this accumulates, your
cleaner will not operate effectively.
IMPORTANT
All new carpet has loose fibers which can fill the
bag quickly while vacuuming. This type of debris
does not activate the "Check bag" indicator
available on some models.
FILTER BAG:
How to Replace
WARNING
!
To reduce the risk of personal injury, unplug
vacuum before servicing.
Do not use vacuum without filter bag in place.
4.1 To change filter bag, push up door release latch
with thumb and pull handle forward. Remove door.
4.2 Push on the red lever over a trash receptacle
and drop the bag into the trash.
IMPORTANT
Do not clean out old filter bag and reuse.
Discard used filter bag.
4.3 Hold new filter bag as shown. Slide the
cardboard sleeve into the bag holder until the bag
is securely in place.
4.4 Reposition bag door by placing tabs on bottom
of door into opening (C). Make sure the filter bag is
securely tucked into the vacuum.
Push door handle to snap securely shut.

4. MAINTENANCE

NOTICE
!
Very fine materials, such as face powder or
cornstarch, may seal the filter bag and may
cause it to burst even though it is partially full of
dirt. When the cleaner is used to remove
material of this nature, change filter bag often.
4.1
!
4.3
9
!
CAUTION
!
What to Buy: Filter bag
Use only genuine HOOVER
vacuum. When purchasing a new bag, ask
for HOOVER ® HEPA Type Y Bag Part
#902419001 or Carbon HEPA Type Y Bag
Part #902481001.
Actual model may vary from images shown.
!
®
bags with your
4.2
4.4
C