Apm Configuration - Asus M2N DH User Manual

4.5.5

APM Configuration

APM Configuration
Power Button Mode
Restore on AC Power Loss
Power On By PCI Devices
Power On By PCIE Devices
Power On By LAN(MAC)
Power On By Ring
Power On By PS/2 KB/MS
Power On By USB
Power On By RTC Alarm
Power Button Mode [On/Off]
Allows the system to go into On/Off mode or suspend mode when the power
button is pressed. Configuration options: [On/Off] [Suspend]
Restore on AC Power Loss [Last State]
When set to Power Off, the system goes into off state after an AC power loss.
When set to Power On, the system goes on after an AC power loss. When set to
Last State, the system goes into either off or on state, whatever the system state
was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
Power On By PCI Devices [Disabled]
When set to [Enabled], this parameter allows you to turn on the system through a
PCI LAN or modem card. This feature requires an ATX power supply that provides
at least 1A on the +5VSB lead. Configuration options: [Disabled] [Enabled]
Power On By PCIE Devices [Disabled]
When set to [Enabled], this parameter allows you to turn on the system through
a PCIE LAN or modem card. This feature requires an ATX power supply that
provides at least 1A on the +5VSB lead. Configuration options: [Disabled]
[Enabled]
Power On By LAN(MAC) [Disabled]
When set to [Enabled], this parameter allows you to turn on the system through a
PCI LAN or modem card. This feature requires an ATX power supply that provides
at least 1A on the +5VSB lead. Configuration options: [Disabled] [Enabled]
Power On By Ring [Disabled]
Allows you to enable or disable the RI to generate a wake event. Configuration
options: [Disabled] [Enabled]
ASUS M2N / M2N DH
[On/Off]
[Last State]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
4-29