Table of Contents
Advertisement
7 • Installing the Switch Housing
Lower Switch
Housing
10
Steps 7-2 – 7-4
Housing
Assembly
Screw
Clearance
Hole
Plug
Connector
Locator
Post
Steps 7-6 – 7-7
Hunter Fan Company
e upper and lower switch housings come preassembled from the
Upper
factory. You will need to remove the lower switch housing before you
Switch
can install the upper switch housing to the fan.
Housing
7-1. To remove the lower switch housing, uninstall the two screws
from the lower switch housing.
7-2. To attach the upper switch housing, partially install two #6-32 x 3/8"
Step 7-1
housing assembly screws into the switch housing mounting plate.
7-3. Feed the plug connectors through the center opening of the
housing.
7-4. Align the keyhole slots in the housing with the housing assembly
screws.
7-5. Turn the housing counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole slots.
Install the remaining #6-32 x 3/8" screw into the housing. Tighten
all three screws firmly.
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the
switch housing falling.
Upper
7-6. Connect the plug connectors. Note: Both plug connectors
Switch
Housing
are polarized and will only fit together one way. Make sure the
connectors are properly aligned before connecting them. Incorrect
connection could cause improper operation and damage to the
product.
7-7. Align the locator posts in the lower switch housing with the
clearance holes in the upper switch housing. Place the lower
switch housing assembly over the upper switch housing. Align the
screw holes in the upper and lower switch housings. Attach the
lower switch housing to the upper switch housing with two #8-32
x 3/8" housing assembly screws.
41893-01 • 08/29/05
Advertisement
Table of Contents
