Enter Static Ip Address; Select Interface Options - Efficient Networks SpeedStream 5100 Series User Manual

Enter Static IP Address

1. On the PPP Static IP window, you may
enter a static IP address if your service
provider has assigned one (not required).
2. To continue to the Interface Options
window, click Next.

Select Interface Options

1. On the Interface Options window, select
the desired options:
•
Use Firewall:
Enable firewall protection.
•
Use Attack Detection System:
Enable WAN attack protection.
•
Use Universal Plug-n-Play:
Enable devices to discover and control each other via UPnP over the network.
•
RIP:
Routing Information Protocol (For more information, see page 83.)
- Version 1:
Allows RIP version 1 to be
transmitted/received on the
selected interface. Currently,
RIPv1 is seldom used, but
supported on the SpeedStream
router.
- Version 2:
Allows RIP version 2 to be
transmitted/received on the
selected interface. This would be
the most common choice.
- Versions 1 & 2:
Simultaneously supports RIP
versions 1 and 2 on the selected
interface.
- Active Mode:
In enabled, the router will receive
routing updates on the selected
interface and will broadcast regular routing updates to other routers. If not enabled (default),
the router will receive routing updates on this interface, but will not broadcast routing tables.
•
NAT/NAPT:
Enable Network Address Translation (NAT) and/or Network Address Port Translation (NAPT).
For more information on using NAT and NAPT, see page 65.
SpeedStream Router User Guide
51