Efficient Networks SpeedStream 5100 Series User Manual page 122

5b. If you selected the
Step On this window:
5b Interface Options
6 Connection Name
7 VC Wizard
5c. If you selected the
Step On this window:
5c 2684 Bridged
6 Interface Options
7
Connection Name
8
PPPoE Session Count
9
User Information
10
PPP Options
11
PPP Static IP
12
Interface Options
13 Connection Name
14 VC Wizard
5d. If you selected the
connection also use 2684B Connection:
If you elected not to have the virtual connection also use 2684B Connection, steps 6, 7 and 8 are not relevant,
Note
and those windows will not display.
Step On this window:
5d PPPoE with Bridge
6 2684 Bridged
7 Interface Options
8 Connection Name
9 PPPoE Session Count
PPPoE protocol and
PPPoE / Bridged type:
Do this:
Select interface options: firewall, attack detection system, universal plug
and play; RIP; NAT/NAPT.
Enter name to use for this connection.
Finish.
PPPoE protocol and
2684B Connection type:
Do this:
Enter Internet protocol information as provided by your service provider.
Select interface options: firewall, attack detection system, universal plug
and play; RIP; NAT/NAPT.
Enter name to use for this connection.
Specify the number (1-4) of PPP sessions you want to configure. For each
session, steps 7-11 will repeat.
Enter user name and password (both are optional).
Select PPP options for this connection: dial-up mode, auto-connect on
disconnect, idle timeout
Enter static IP address (optional).
Select interface options: firewall, attack detection system, universal plug
and play; RIP; NAT/NAPT.
Enter name to use for this connection. If multiple sessions were selected,
repeat steps 7-11 until last session is configured; then go to step 12.
Finish.
PPPoE protocol and
PPPoE Bridge type, and elected to have the virtual
Do this:
Specify whether the virtual circuit (VC) should also use a 2684 Bridged
connection.
Enter Internet Protocol information as provided by your service provider.
Select interface options: firewall, attack detection system, universal plug
and play; RIP; NAT/NAPT.
Enter name to use for this connection.
Specify the number (1-4) of PPP sessions you want to configure. For each
SpeedStream Router User Guide
112