Ethernet Installation Method - Efficient Networks SpeedStream 5100 Series User Manual

SpeedStream Router User Guide
Some models may have a power switch on the router case,
Note
as illustrated:

Ethernet Installation Method

To connect the SpeedStream router via the Ethernet
interface, your computer must have an Ethernet
adapter (network interface card, or "NIC") installed. If
your computer does not have this adapter, you will
need to install it before proceeding further. Refer to
the Ethernet adapter documentation for complete
installation instructions.
1. Make sure the router is not plugged in to the electrical outlet.
2. Connect the Ethernet straight-through cable to the Ethernet port on the router.
3. Connect the other end of the Ethernet cable to the Ethernet port on your computer.
4. Plug the telephone cable into the DSL port on the router.
5. Plug the other end of the telephone cable into the telephone jack.
If using a two-to-one adapter, plug the cable into the open socket.
Note
6. Plug the power adapter into the router and the electrical outlet.
When using the Ethernet installation method, you do not have to install any software. Refer to your
Internet Service Provider's instructions for installing their software and/or connecting to the Internet.
You can now configure the TCP/IP settings as detailed on page 9 in
Chapter 3, Configuring Computer
.
Network Settings
7