Efficient Networks SpeedStream 5100 Series User Manual page 121

Step On this window:
8
VC Wizard
4c. If you selected the RFC-2684 Routed protocol:
Step On this window:
4c 2684 Routed
5 Interface Options
6 Connection Name
7 VC Wizard
4d. If you selected the PPPoE protocol:
Step On this window:
4d
PPPoE Type
5
This step is dependent on your choice of protocol. Click the protocol type to jump to the specific
configuration procedures.
5a PPPoE Client
5b PPPoE Bridge
5c PPPoE 2684B Connection
5d PPPoE with PPPoE Bridge
5a. If you selected the
Step On this window:
5a
PPPoE Session Count
6
User Information
7
PPP Options
8
PPP Static IP
9
Interface Options
10 Connection Name
11 VC Wizard
Do this:
Finish.
Do this:
Enter Internet Protocol information as provided by your service provider.
Select interface options: firewall, attack detection system, universal plug
and play; RIP; NAT/NAPT.
Enter name to use for this connection.
Finish.
Do this:
Select PPPoE type: client, bridged, 2684 connection, or PPPoE bridge.
PPPoE protocol and Client type:
Do this:
Specify the number (1-4) of PPP sessions you want to configure. For each
session, steps 4-8 will repeat.
Enter user name and password (both are optional).
Select PPP options for this connection: dial-up mode, auto-connect on
disconnect, idle timeout.
Enter static IP address (optional).
Select interface options: firewall, attack detection system, universal plug
and play; RIP; NAT/NAPT.
Enter name to use for this connection. If multiple sessions were selected,
repeat steps 4-8 until last session is configured; then go to step 6.
Finish.
SpeedStream Router User Guide
111