Care And Cleaning; Care Of Drain Air Gap; Overfill Protector - Frigidaire PLD4555RFC - Full Integrated Dishwasher Use And Care Manual

Care and Cleaning

Allow heating element to cool before
cleaning the interior.
Failure to do so can result in burns.
Outside—Occasionally wipe with a mild
nonabrasive detergent and water. Rinse and dry.
Models with Easy Care Real Stainless Finish
—Clean outer door with warm soapy water and a
dishcloth or sponge. Rinse with clean water and a
dry cloth. Do not use harsh cleaners.
Inside—The inside of the dishwasher is self-
cleaning with normal use. If needed, clean around
the tub gasket area with a damp cloth.
The filter is self-
cleaning. A glass
trap located in the
center of the filter
is designed to
collect pieces of
broken glass,
straws, bones
and pits. To
remove items in
glass trap, grasp
handle, lift out,
empty and
replace.
Note: Hard water may cause lime deposit buildup
on the interior of the dishwasher.

Overfill Protector

overfilling and is located in the left front corner of
the tub.
• Clean occasionally with
household cleaner
containing vinegar or
bleach to dissolve any
buildup.
• Overfill Protector
should move up and
down freely about one
inch. If it does not
move, lift and clean
underneath.
Burn Hazard
—keeps dishwasher from

Care of Drain Air Gap

f a drain air gap was installed for your built-in
I
dishwasher, check to make sure it is clean so the
dishwasher will drain properly. A drain air gap is
usually mounted on countertop and can be
inspected by removing the cover. This is not part
of your dishwasher and is not covered by warranty.
Property Damage Hazard
Freezing temperatures may cause water lines to
rupture. Be sure all supply lines to and circulating lines
within dishwasher are protected. Failure to do so could
result in property damage.
Winterizing
A dishwasher left in an unheated place should be
protected from freezing. Have a qualified person
do the following:
To Disconnect Service:
1. Turn off electrical power to the dishwasher at
the supply source by removing fuses or
tripping circuit breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain
water into pan.
Note: See Installation Instructions for more
details.
To Restore Service:
1. Reconnect the water, drain, and electrical
power supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher
through a ULTIMATE SCRUB cycle.
4. Check connections to make sure they do not
leak.
Note: See Installation Instructions for more
details.
7