Lenovo 7360D6U - THINKCENTRE M58 7360 Hardware Maintenance Manual page 58

Diagnostic Error Code
011-001-XXX Serial port Presence
011-002-XXX 011-003-XXX Serial port Timeout/Parity
error
011-013-XXX 011-014-XXX Serial port Control
Signal/Loopback test failure
011-015-XXX Serial port External Loopback failure
011-027-XXX Serial port Configuration/Setup error
011-03X-XXX 011-04X-XXX Serial port failure
011-195-XXX Serial port Test aborted by user
011-196-XXX Serial port test halt, error threshold
exceeded
011-197-XXX Serial port test warning
011-198-XXX Serial port test aborted
011-199-XXX Serial port test failed, cause unknown
011-2XX-XXX Serial port signal failure
014-000-XXX Parallel port Interface Test Passed
014-001-XXX Parallel port Presence
014-002-XXX 014-003-XXX Parallel port Timeout/Parity
error
014-013-XXX 014-014-XXX Parallel port Control
Signal/Loopback test failure
50
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. Remove external serial device, if present
2. Run setup, enable port
3. System board
System board
System board
1. Wrap plug
2. System board
1. Run Setup, enable port
2. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 554
3. System board
System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 39
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 39
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 554
3. Go to "Undetermined problems" on page 65
1. Go to "Undetermined problems" on page 65
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 554
3. Replace component under function test
1. External serial device
2. System board
No action
1. Remove external parallel device, if present
2. Run setup, enable port
3. System board
System board
System board