Cabletron Systems MMAC-Plus 9T125-08 Reference Manual page 21

And if the port is
If the port is a...
Ring Port
RI (ring-in) or
RO (ring-out)
Lobe Port
Exiting the Port Configuration Screen
To exit the Port Configuration Screen, use the arrow keys to highlight RETURN,
then press the Return key.
Table 4. Token Ring Port Operational Codes
administratively
turned...
ACT (Active)
The port is on and is passing data to the ring.
ON
WRP (Wrapped)
The port is on, but it is autowrapped, either because of a
cable failure or because the cable is not connected.
OFF DIS (Disabled)
The port is off (wrapped by Management).
INS (Inserted - Phantom link is detected)
The lobe port is inserted into the ring.
ON
ENB (Enabled - No phantom link is present)
The lobe port is not inserted into the ring.
LNK (Linked - Phantom link is detected)
The lobe port is trying to gain access to the ring, but it has
OFF been prevented.
BYP (Bypassed - No phantom link is present)
The lobe port is not attempting to gain access to the ring.
FLT (Speed Fault)
ON or OFF The ring speed of the port is in conflict with the ring speed
of the designated token ring. The port will remain
wrapped.
9T125-08 Module Specific Information
Then, the operational status is:
19