Linksys WUSBF54G User Manual page 9

Chapter 3
WPA-Personal (Wi-Fi Protected Access)
If your network has the wireless security WPA-Personal
enabled, this screen will appear.
WPA-Personal Needed for Connection
Encryption
Select the type of algorithm you want to use,
TKIP or AES, from the Encryption drop-down menu.
Passphrase Enter a Pre-shared key of 8-63 characters in
the Passphrase field.
Then click Connect and proceed to the Congratulations
screen.
After the software has been successfully installed, the
Congratulations screen will appear. Click Connect to
Network to connect to your network.
Congratulations
Congratulations! Setup is complete.
Wireless-G USB Network Adapter with Wi-Fi Finder
Manual Setup
If your network is not listed with the available networks,
you can use Manual Setup.
1. Click Manual Setup on the Available Wireless Network
screen to set up the Adapter manually.
Available Wireless Networks
2. The Network Settings screen from the Wireless Network
Monitor will appear. If your network has a router or
other DHCP server, click the Obtain network settings
automatically (DHCP) radio button.
Network Settings
If your network does not have a DHCP server or router,
click the Specify network settings radio button. Enter
an IP Address, Subnet Mask, Default Gateway, and DNS
addresses appropriate for your network. You must
specify the IP Address and Subnet Mask on this screen.
If you are unsure about the Default Gateway and DNS
addresses, leave these fields empty.
IP Address This IP Address must be unique to your
network.
Configuration
6