Linksys WUSBF54G User Manual page 19

Chapter 4
WPA-Personal Needed for Connection
WPA-Personal Needed for Connection
Encryption Select the type of algorithm you want
to use, TKIP or AES, from the Encryption drop-down
menu.
Passphrase
Enter a Passphrase, also called a pre-
shared key, of 8-63 characters in the Passphrase field.
The passphrase must match the devices on your
wireless network.
Then, click Connect and proceed to the Congratulations
screen. To cancel the connection, click Cancel.
2. After the software has been successfully installed, the
Congratulations screen will appear. Click Connect to
Network to connect to your network.
Congratulations
Congratulations! The profile has been configured.
Wireless-G USB Network Adapter with Wi-Fi Finder
Using the Wireless Monitor
Setting Up the Adapter with Manual Setup
If your network is not listed among the available networks,
click Manual Setup on the Available Wireless Network
screen to set up the adapter manually.
Available Wireless Network
1. After clicking Manual Setup, the Network Settings
screen will appear. If your network has a router or other
DHCP server, click the radio button next to Obtain
network settings automatically (DHCP).
Network Settings
If your network does not have a Router or DHCP
server, click the radio button next to Specify network
settings. Enter an IP Address, Subnet Mask, Default
Gateway, and DNS addresses appropriate for your
network. You must specify the IP Address and Subnet
Mask on this screen. If you are unsure about the Default
Gateway and DNS addresses, leave these fields empty.
IP Address
This IP Address must be unique to your
network.
Subnet Mask
The Adapter's Subnet Mask must be
the same as your wired network's Subnet Mask.
16