Chapter 3: Configuration; Connecting The Adapter - Linksys WUSBF54G User Manual

Chapter 3
Chapter 3:
Configuration
The Wireless-G USB Network Adapter with Wi-Fi Finder
is set up with the Setup Wizard that comes on the CD
enclosed with the Adapter. This chapter will guide you
through the setup procedure.
IMPORTANT:
Do not connect the Adapter until
you are instructed to do so or the setup will not
work.
Insert the Setup Wizard CD-ROM into your CD-ROM drive.
The Setup Wizard should run automatically, and the
Welcome screen should appear. If it does not, click the
Start button and choose Run. In the field that appears,
enter D:\setup.exe (if "D" is the letter of your CD-ROM
drive).
Welcome Screen
On the Welcome screen, you have the following choices:
Click Here to Start Click the Click Here to Start button
to begin the software installation process.
User Guide Click the User Guide button to open the PDF
file of this User Guide.
Exit Click the Exit button to exit the Setup Wizard.
1. To install the Adapter, click the
button on the Welcome screen.
Wireless-G USB Network Adapter with Wi-Fi Finder
Click Here to Start
2. After reading the License Agreement, click the
Next button if you agree and want to continue the
installation, or click the Cancel button to end the
installation.
License Agreement
Windows will begin copying the files onto your PC.
3. The Setup Wizard will now prompt you to install the
Adapter into your PC. Click Next and power off your
PC. After installing the Adapter, as shown below, and
restarting your PC, the Setup Wizard will continue.

Connecting the Adapter

Installing the Adapter
1. Insert the USB connector end of the Adapter into the
USB port of the PC.
2. The Power LED should light up when the Adapter is
plugged in.
Configuration
4