NETGEAR WG602NA User Manual page 41

• Disable
• Allow
• Block
Then, enter the MAC address for a device you plan to use. You can usually find the MAC
3.
address printed on the wireless adapter.
You can copy and paste the MAC addresses from the WG602 v3's Station List page into the
MAC Address box. To do this, configure each wireless PC to obtain a wireless link to the
WG602 v3. The PC should then appear in the Station List page.
Click Add to add the wireless device to the access list. Repeat these steps for each additional
4.
device you want to add to the list.
Be sure to click Apply to save your wireless access control list settings.
5.
Now, only devices on this list will be allowed to wirelessly connect to the WG602 v3. For blocking
access from specific devices, follow the procedure above, except select the Block radio button.
Basic Installation and Configuration
User's Guide for the WG602 v3 54 Mbps Wireless Access Point
202-10060-01, September 2004
3-18