NETGEAR WG602NA User Manual page 46

User's Guide for the WG602 v3 54 Mbps Wireless Access Point
You cannot perform the firmware upgrade from a workstation connected to the WG602 v3 via a
wireless link. The firmware upgrade must be performed via a workstation connected to the
WG602 v3 via the Ethernet LAN interface.
The software of the WG602 v3 Access Point is stored in FLASH memory, and can be upgraded as
new software is released by NETGEAR. Upgrade files can be downloaded from the NETGEAR
Web site. If the upgrade file is compressed (.ZIP file), you must first extract the image (.IMG) file
before sending it to the wireless access point. The upgrade file can be sent using your browser.
Note: The Web browser used to upload new firmware into the WG602 v3 must support HTTP
uploads, such as Microsoft Internet Explorer 5.0 or above, or Netscape Navigator 4.78 or above.
Download the new software file from NETGEAR, save it to your hard disk, and unzip it.
1.
Figure 4-3: WG602 v3 Upgrade Firmware page
From the main menu Management section, click the Upgrade Firmware link to display the
2.
screen above.
Click Browse and locate the image (.IMG) upgrade file.
3.
Click Upgrade.
4.
When the upload completes, your wireless access point will automatically restart. The upgrade
process typically takes about one minute.
In some cases, you may need to reconfigure the wireless access point after upgrading. You can
click the Information link to check the Firmware Version and verify that your access point now has
the new software installed.
4-4
202-10060-01, September 2004
Management