Vap Configuration Using Snmp; Configuring Radio Settings; Radio Configuration From The Web Interface - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
VAP Configuration Using SNMP
1. Load the DLINK‐WLAN‐ACCESS‐POINT‐MIB module.
2. From the MIB tree, navigate to the objects in the apVap table.
3. Walk the apVapDescription object to view the instance ID for VAP 1 (wlan0vap1).
VAP 1 on Radio 1 is instance 3.
4. Use the apVapStatus object to set the status of VAP 1 to up (1).
5. Use the apVapVlanID object to set the VLAN ID of VAP 1 to 2.
6. Navigate to the objects in the apIfConfig table.
7. Walk the apIfConfigName object to view the instance ID for VAP 1 (wlan0vap1).
VAP 1 on Radio 1 is instance 3.
8. Set the value of instance 3 in the apIfConfigSsid object to Marketing.
9. Set the value of instance 3 in the apIfConfigSecurity object to wpa‐personal (3).
10. Set the value of instance3 in the apIfConfigWpaPersonalKey object to JuPXkC7GvY$moQiUttp2, which is
the WPA pre‐shared key.
11. Navigate to the objects in the apRadioBss > apBssTable table.
12. Walk the apBssDescr object to view the instance ID for VAP 1.
VAP 1 on Radio 1 is instance 1.
13. Set the value of instance 1 in the apBssWpaAllowed object to false (2).
14. Set the value of instance 1 in the apBssWpaCipherTkip object to false (2).
15. Set the value of instance 1 in the apBssWpaCipherCcmp object to true (1).
Configuring Radio Settings
This example shows how to configure Radio 2 with the following settings:
• Mode: IEEE 802.11b/g/n
• Channel: 6
• Channel Bandwidth: 40 MHz
• Maximum Stations: 100
• Transmit Power: 75%
Radio Configuration from the Web Interface
1. Log onto the AP and navigate to the Manage > Radio page.
2. Make sure the number 2 appears in the Radio field and that the status is On.
3. From the Mode menu, select IEEE 802.11b/g/n.
4. From the Channel field, select 6.
D-Link
November 2011
Configuring Radio Settings
Unified Access Point Administrator's Guide
Page 166