D-Link DWL-3600AP Administrator's Manual page 140

Unified Access Point Administrator's Guide
Field
Match Every
Protocol
IPv4 Class Maps
Source IP Address
Source IP Mask
Destination IP Address
Destination IP Mask
D-Link
November 2011
Table 54: DiffServ Class Map (Cont.)
Description
Select Match Every to specify that the match condition is true to all the
parameters in an L3 packet.
All L3 packets will match an Match Every match condition.
Select the Protocol field to use an L3 or L4 protocol match condition based on
the value of the IP Protocol field in IPv4 packets or the Next Header field of IPv6
packets.
Once you select the field, choose the protocol to match by keyword or enter a
protocol ID.
Select From List
Select one of the following protocols from the list:
• IP
• ICMP
• IPv6
• ICMPv6
• IGMP
• TCP
• UDP
Match to Value
To match a protocol that is not listed by name, enter the protocol ID.
The protocol ID is a standard value assigned by the IANA. The range is a number
from 0 – 2 55.
Select this field to require a packet's source IP address to match the address
listed here. Enter an IP address in the appropriate field to apply this criteria.
Enter the source IP address mask.
The mask for DiffServ is a network‐style bit mask in IP dotted decimal format
indicating which part(s) of the destination IP Address to use for matching
against packet content.
A DiffServ mask of 255.255.255.255 indicates that all bits are important, and a
mask of 0.0.0.0 indicates that no bits are important. The opposite is true with
an ACL wild card mask. For example, to match the criteria to a single host
address, use a DiffServ mask of 255.255.255.255. To match the criteria to a 24‐
bit subnet (for example 192.168.10.0/24), use a mask of 255.255.255.0.
Select this field to require a packet's destination IP address to match the
address listed here. Enter an IP address in the appropriate field to apply this
criteria.
Enter the destination IP address mask.
The mask for DiffServ is a network‐style bit mask in IP dotted decimal format
indicating which part(s) of the destination IP Address to use for matching
against packet content.
A DiffServ mask of 255.255.255.255 indicates that all bits are important, and a
mask of 0.0.0.0 indicates that no bits are important. The opposite is true with
an ACL wild card mask. For example, to match the criteria to a single host
address, use a DiffServ mask of 255.255.255.255. To match the criteria to a 24‐
bit subnet (for example 192.168.10.0/24), use a mask of 255.255.255.0.
Creating a DiffServ Class Map
Unified Access Point Administrator's Guide
Page 140