Appendix A: Default Ap Settings; Table 66: Uap Default Settings - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
A p p e n d i x A : D efau l t A P S et t i n g s
When you first power on a UAP, it has the default settings shown in the following table.
Note: The DWL‐3600AP supports one radio, and it is capable of operating in the IEEE 802.11b,
802.11g, and 802.11n (2.4 GHz) modes. Radio 1 (802.11a/n) settings do not apply to the
DWL‐3600AP.
Feature
System Information
User Name
Password
Ethernet Interface Settings
Connection Type
DHCP
IP Address
Subnet Mask
DNS Name
Management VLAN ID
Untagged VLAN ID
IPv6 Admin Mode
IPv6 Auto Config Admin Mode
Radio Settings
Radio (1 and 2)
Radio 1 IEEE 802.11 Mode
Radio 2 IEEE 802.11 Mode
802.11a/n Channel
802.11b/g/n Channel
Radio 1 Channel Bandwidth
Radio 2 Channel Bandwidth
Primary Channel
Short Guard Interval Supported
STBC Mode
Protection
Maximum Wireless Clients
Transmit Power
D-Link
November 2011
Table 66: UAP Default Settings
Default
admin
admin
DHCP
Enabled
10.90.90.91 (if no DHCP server is available)
255.0.0.0
None
1
1
Enabled
Enabled
On
802.11a/n
802.11b/g/n
Auto
Auto
40 MHz
20 MHz
Lower
Yes
On
Auto
200
100 percent
Default AP Settings
Unified Access Point Administrator's Guide
Page 161