Checking The Led Indicators - 3Com 3CRWEASYA73 - 11a 54 Mbps Wireless LAN Outdoor Quick Start Manual

7

Checking the LED Indicators

The bridge's 11a and 11b/g LEDs operate in two display modes, which are configurable through the
software. The default AP mode indicates data traffic rates. The RSSI mode indicates the received signal
power and is for use when aligning antennas in a bridge link.
When the bridge is connected to power, LEDs indicate as follows:
LED Color
Power Green
Off
Amber
Link Green
Flashing
Off
11a Green
and
(Three
Flashing
LEDs)
Off
11g Amber
and
(Three
Flashing
LEDs)
Off
11
Indicates
The bridge is powered up and operating
normally.
The bridge is not receiving power or there is a
fault with the power supply.
The system is under cold reset status.
The bridge has a 10/100 Mbps Fast Ethernet
connection, but there is no activity.
Indicates that the bridge is transmitting or
receiving data on a 10/100 Mbps Ethernet LAN.
Flashing rate is proportional to network activity.
No link is present or the Ethernet LAN port is
disabled.
The 802.11a 5.3 GHz radio is enabled.
RSSI Mode:
One fully lit LED indicates a low RSSI output
•
level, two LEDs.a medium level, and three
LEDs the maximum level.
A flashing LED indicates an intermediate RSSI
•
output level
AP Mode:
One fully lit LED indicates a low traffic rate,
•
two LEDs.a medium rate, and three LEDs the
maximum rate.
A flashing LED indicates an intermediate
•
traffic rate level
No link is present or the 802.11a radio is
disabled.
The 802.11g 2.4 GHz radio is enabled.
RSSI Mode:
One fully lit LED indicates a low RSSI output
•
level, two LEDs.a medium level, and three
LEDs the maximum level.
A flashing LED indicates an intermediate RSSI
•
output level
AP Mode:
One fully lit LED indicates a low traffic rate,
•
two LEDs.a medium rate, and three LEDs the
maximum rate.
A flashing LED indicates an intermediate
•
traffic rate level
No link is present or the 802.11g radio is
disabled.